PfSense -> 24 port switch -> everything else (including desktops, servers, wireless access points, I use Ubiquiti Unifi)Īll wireless devices then connect via Every consumer switch is designed differently, but most that I have used allow you to operate them as a Wireless AP if you just plug them in using the LAN ports on the inside of your network.Īll you have to do then is set up the SSID and password on the Netgear router, and it should just act as a bridge between its LAN ports and WiFi. I would recommend you use pfSense for routing, firewall and DHCP and leave any Wireless AP or Switching to dedicated hardware devices. It is - however- one of the best firewalls and routers out there. While you can get pfSense to do all of these things, it usually does not do all of them well. There are ways to bridge ports and make them act as a old school hub if you have a device with many ports, but this tends to perform horribly.Ī typical consumer router is kind of a multi-purpose device typically containing a few things: PfSense is not intended to work the same way as a consumer router does. nor will plex clients connect.Īll settings have been left at default minus what was needed to setup pfsense originally as a dead basic router.Īs always help is you using a hardware switch, or plugging the Windows computers into multiple ports on your pfSense box? None of the computers can see each other on the network or share files nor can i connect a wireless network printer so i can print from my mobile devices. laptop where the downloading and viewing takes place. I recently setup pfsense on a mini computer with an aes-ni processor for vpn encryption/wifi router.Īll computers have internet connectivity and can connect via wifi (though the media computers are wired and only mobile devices connect via wifi) the roles of the computer is as follows. im just not sure exactly what im looking for beyond the general term of "networking" and was hoping someone could link me to step by step instructions as im unaware if this a firewall issue or something that needs to be configured windows side or a nat issue or what.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |